Jansen Egeplast HexelOne® SLM
The high-pressure pipe system made of PE
The self-reinforced high-pressure pipe system with permissible operating pressure of 30 bar for water / 16 bar for gas (SVGW-approved up to 5 bar)
Das Jansen Egeplast HexelOne® SLM pipe is a self-reinforced high-pressure pipe, a mono-composite consisting of PE only. This reinforcement makes the pipe suitable for application in the "increased pressure" range, i.e. for operating pressures above those covered up to now by PE pipes. The reason: compared to conventional PE pipes, these pipes have twice the strength.
Construction
- Protective sleeve pipe
- Solid wall pipe made of PE 100 RC, high-strength PE for increased pressure resistance; outer layer of PE 100; additional protection layer of PE plus
Dimension
dn 90 – 160 mm (others on request)
Pressure grades
- dn 90 - 140; 30 bar
- dn 160; 25 bar
Application
- Water
- Gas
- Wastewater
- Industry
Installation method
- Open trench
- Relining
- Hydraulic drilling
- Berstlining
- Ploughing method
- Milling method
Special features
Lengths of up to 145 m available; high operating pressures without hydraulic loss
PAS 1075 type
-
Embedding when installed in the ground
Gravel or sand up to 32 mm
JANSEN Egeplast HexelOne® SLM pressure pipe
in lengths of 12 m, smooth ends
| Nominal pressure | Series / SDR | Dimensions dn |
| PN 25 | 5 / 11 | 160 mm |
| PN 30 | 5 / 11 | 90 - 140 mm |
JANSEN Egeplast HexelOne® SLM pressure pipe
in coils of 100 m, smooth ends
| Nominal pressure | Series / SDR | Dimensions dn |
| PN 25 | 5 / 11 | 160 mm |
| PN 30 | 5 / 11 | 90 - 140 mm |
